![]() ![]() The Ready LED and Error LED blink irregularly while the firmware being rewritten. After finishing receiving the files, the machine starts to rewrite the firmware. The files in the firmware are sent to the machine so that they are started to write into the flash ROM automatically. (6) Drag the firmware (LZ.) in the same folder and drop it onto the icon of the applicable model in FILEDG32. (5) Click the Brother Maintenance USB printer driver in FILEDG32 to select. Make sure that there is the printer icon of the connected machine, and that no error occurs. (4) Open the “hl2100” folder and double-click the FILEDG32.EXE icon to start. When doing this operation at the first time, the Plug & Play program is performed, and the driver is installed. (The USB serial number is fixed to “B01234567890”.) Then, make sure that the Toner/Drum/Error LED lights up, and close the front cover. Make sure that the Toner/Drum/Error LED lights up, and release the SW supporter, Make sure that all LEDs are off, and press the SW supporter four times. (2) Open the front cover, and turn the power supply of the machine on while holding down the SW supporter. (1) Connect the PC and machine with the USB cable. If the Brother Maintenance USB Printer Driver has already been installed to your PC, start to rewrite the program files. ![]() ![]() After the installation procedure of the Brother Maintenance USB Printer driver is completed, refer to the following steps for the detailed procedures to rewrite the program files. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |